HarleyTechTalk

hi all, many thanks to all who have offered advice in the past. I have just completed some major cam work,inner/outer bearings,tensioners and pushrods . During this work i had the earth off the battery and the fuel pump relay fuse out. To spin the engine to central up the oil pump as per manual  i replaced the earth but left the fuse out of the fuel pump relay and spun the engine as necessary.I have just finished setting up the adjustment on the pushrods ,cam cover back on put the fuse back in for the relay and now the engine light is on showing codes 23/32 this is both injectors. The power for these is from the fuel pump relay...Have i done something wrong by spinning the engine with the fuse out? any advise please as the other option will be a Harley dealer. thanks Dave

I guess what's missing here is how the engine runs?
Bob

If you powered up the ECM without the injectors or pump connected, its very likely they'd kick out codes telling you they where not functioning at that point. Recycle the ignition on-off three times, then try to start her up. Buffalo

many thanks Buffalo, bike starts fine, no engine lights. but have a strange squeaky noise that comes and goes. thanks Dave

What bike, what year?  With all the work done, it may take a little looking!  Muffler clamps, heat shield clamps, rear muffler rubber mounts, exhaust touching, exhaust leaking, floorboard rubbers, engine mounts.
Hell, as you can see it could be anything, oh yeah fender marker lights, headlight rims, it just goes on.
Good luck  Buffalo 

lol.thanks again